Ubiquiti Networks UniF AP AC Outdoor - Manual (Page 35)

32
Chapter 9: Access Point Details UniFi ® Controller User Guide
Ubiquiti Networks, Inc.
Chapter 9: Access Point
Details
UniFi Access Points connect to the UniFi Controller
software either by Ethernet, indicated as Connected, or by
a wireless connection, indicated as Connected (wireless).
Based on connection type, options under each tab vary.
Note: The UniFi AP-AC and AP-AC Outdoor do not
support wireless uplinks for the initial release, but
they will with a future firmware upgrade.
The upper part of the window has four clickable tabs:
• Details (see below)
• “Users” on page 35
• “Guests” on page 35
• “Configuration” on page 36
The bottom of the window has two buttons:
•
Locate Use the Locate button to flash the LED on the
Access Point and flash the Access Point icon on the map.
• Restart Use the Restart button to restart the
Access Point.
Note: The UAP-AC, UAP-PRO, and UAP models are
shown in this chapter; however, this information also
applies to the other UniFi AP models.
Details
Details about the Access Point. Click Overview to display
the device specifics, connection details, uptime, and user
statistics.
Overview
MAC Address Displays the MAC address of the
Access Point.
Model Displays the model number.
Version Displays the version of software used on the
Access Point.
IP Address Displays the IP address of the Access Point.
Uptime Displays the amount of time the Access Point has
been running without interruption.
# Users Displays the number of users connected to the
primary network.
# Guests Displays the number of users connected to the
guest network.
Uplink (Wireless)
Click Uplink (Wireless) to display details about the
wireless uplink. See “Wireless Uplinks” on page 39 to
find, select, and connect to a wireless Access Point.
Uplink AP Displays the name or MAC address of the
Uplink Access Point.
Signal Displays the percentage of signal strength
between the two APs.
TX Rate Displays the TX (transmit) rate.
RX Rate Displays the RX (receive) rate.
Down Pkts/Bytes Displays the amount of data
downloaded as packets and bytes.
Up Pkts/Bytes Displays the amount of data uploaded as
packets and bytes.
Activity Displays the level of activity in Bytes per second.