VDO WR MC 2.0 - Manual (Page 48)

MC 2.0 WR VDO CYCLECOMPUTING 48
DE ENG FR ES IT NL PL
5 Installation
5.1 Fitting the sensor, magnet and handlebar bracket >>> P01
Start by fitting the sensor and magnet.
Step 1 Place the rubber pad under the sensor. Fit the sensor on the
same side of the forks where you later want to fit the computer to the
handlebars (right or left) using the cable ties supplied (loosely at first,
do not pull tight just yet).
ATTENTION: the sensor mark on the sensor must point to the spokes.
Depending on the room available, the sensor can be fitted at the front
of the forks, on the inner side (side showing to spokes) of the forks or
pointing backwards on the forks.
>>> P02
Step 2 Place the spoke magnet around an outer spoke. The silver
centre of the magnet points towards the sensor. Align the magnet to
the sensor mark on the sensor leaving a gap of about 1 - 5 mm.
Step 3 Align the sensor and magnet for good and fasten them in place:
pull the cable ties tight and push the magnet in firmly.
Step 4 Decide whether fitting to handlebars or stem and rotate the
base of the handlebar holder by 90° accordingly. To do so, undo the
screws in the bracket, take out the foot and rotate it 90°, insert and
tighten the screws again.
ATTENTION: do not overtighten the screws.
Step 5 Guide the cable ties through the slot in the handlebar bracket,
place around the handlebars or the stem and pull (do not pull tight
just yet).
Step 6 If fitting to handlebars: align the computer angle to achieve
optimum readability. Now pull the cable ties tight. Snip off protruding
ends with clippers.