Velodyne Digital DrivePLUSSeries - Manual (Page 27)

REMOTE CONTROL BUTTON COMMANDS
Following are commands and their remote control button sequences. Unless otherwise noted, these sequences work only on the
Introductory screen.
Remote Control Button Sequence Commands for TV-based Interface
Command Button Sequence Description
Go to System Response screen 1 – 2 – 3 – 4 – 5 On the Introductory screen
Self-EQ 3 – 2 – 1 Initiate Self-EQ optimization. Be sure to connect the
microphone before engaging. After 28 sweeps,
the unit saves and resets.
Cancel Self-EQ and Auto-EQ PLUS RESET Stop and cancel a Self-EQ or Auto-EQ PLUS
optimization process.
Restore defaults 8 – 9 – 0 Restore defaults and reset the subwoofer.
Restore last saved volume RESET If volume is changed, restores last saved volume.
Display serial number ▲ - ▲ - ▲ - ▲ - SELECT Shows the serial number of the unit at the top
of the screen.
Switch PAL/SECAM video ▼ - ▼ - ▼ - ▼ - RESET The unit restarts in PAL/SECAM video mode.
Use 8 -9- 0 (Restore defaults) to return to
NTSC mode.
Go to the System Response Screen
To get to the System Response screen:
1. With the Introductory screen showing on the TV, press 1-2-3-4-5 on the Digital Drive PLUS remote. As you press these buttons, the
numbers display on the Introductory screen as shown in Figure 5.
Figure 5: Introductory Screen
[ 25 ]
Digital Drive PLUS User Interface Manual TV SCREEN USER INTERFACE FOR OPTIMIZATION