Velodyne SC-ICG - Manual (Page 9)

www.velodyne.com SC-ICG User’s Manual - 5
7. Push the backside of the basket flange flush with the ceiling material, and tighten the four screws on the
basket engaging the clamps. The four screws should be hand tightened, or torqued to 4 inch pound.
8. Carefully push the aluminum grille into the groove on the grille basket. Ensure that the flange and the
grille edge are flush.
Figure 4. Push the SC-600 In-Ceiling Grille into the grille basket.
New Construction
1. designate a suitable location for for the installation of the velodyne in-ceiling subwoofer, during the
framing construction. Mark the driver location by stapling the mud ring template across the ceiling
beams centered at the designated location.
2. Using the cut-out template, cut a hole in the ceiling material to match the mud ring location.
3. Install the sheet rock. do not remove the mud ring.
4. Follow the “Existing Construction Installation” steps 5-8 to complete the installation of the grille.