Vermona Filter Lancet - analogue multimode filter - Manual (Page 7)

ATTENTION:
Using too little preamplification will decrease the signal to
noise ratio. In addition, trigger sensitivity (see "Envelope-
Generator (EG)", page 14) as well as the envelope-fol-
lower directly depend on the input level setting. Checking
for best possible levels is essential for best results of
your FILTER Lancet.
DRIVE
This control adjusts the amount of distortion applied to the input signal.
Note that DRIVE will take effect on the processed as well as on the dry
signal. With MIX turned fully counterclockwise, the signal can still be
distorted if needed. The distortion can be disabled by switching BYPASS
on. In contrary to distortion achieved with the GAIN control, DRIVE will
not significantly raise the level when increasing the amount of drive.
Output Section (OUT)
The output section offers the following control elements:
Picture 2: Output Section
MIX
This control adjusts the ratio between direct and processed signal. With
MIX turned fully counterclockwise, the input signal passes through the
input section with possible distortion and straight to the output. With
MIX turned fully clockwise, only the signal processed with VCF and VCA
will be audible.
VOLUME
This control sets the output level of FILTER Lancet.
Owner's Manual VERMONA Filter Lancet
- 7 -