Vermona VSR-3 - vintage spring reverb - Manual (Page 5)

Control Surface Features
Front Panel
(1) INPUT
This high-Z jack input (1MΩ) on the front works well with electric
guitars or basses. The inputs on the rear will be muted when this
jack is used.
(2) GAIN
This controller adjusts the input level.
For optimal leveling the corresponding LED should only illuminate
at high level peaks.
(3) TONE
The sound of the reverb effect can be influenced with this
controller.
Low frequencies will be boosted when turning it to the left, on the
opposite high frequencies will be boosted when turning it to the
right. Center position is 12 o'clock.
(4) MIX
This controller sets the value between direct and reverberated
signal.
If the knob is set completely to the left, only the direct signal can
be heard. The fare right position means no direct signal but 100%
reverberation.
(5) OUTPUT LEVEL
This controller adjusts the output level.
(6) EFFECT STOP
This knob turns off the effect signal. It also can be controlled by a
foot switch connected to the rear (9).
Owner's Manual VERMONA VSR-3 - vintage spring reverb
- 5 -