Vermona fourMulator - quad modulation engine - Manual (Page 10)

(2) SPEED- and SPEED/PHASE controls
The SPEED control adjusts the modulators' speed. SPEED covers a range
from approx. 0.05Hz to 100Hz. Therefore, modulations with audible fre-
quencies are only possible within limits. The fourMulator's focus within
the sub audio range is intended because higher frequencies would not
make sense for use of the unit as clock-/trigger-generator or for recipro-
cal modulations.
For modulator 1, the SPEED control is limited to this function. For modu-
lators 2, 3 and 4, this control can also shift the phase of the selected
wave form when being synchronized to the left neighboring unit (SYNC
switch set to left position, see "(3) SYNC-switch", page 11). Here, the LFO
being synchronized runs with the same speed as the reference LFO. Use
SPEED/PHASE to adjust the phase of the wave for the synchronized LFO
between 0° and 180°, shifting the wave form's start-point
Picture 3: Phase Shift
SPEED and SPEED/PHASE offer a third control function. With SYNC set to
the CLK position (Clock), the controls set the clock division in respect to
the incoming clock signal. Find more details in "(3) SYNC-switch" on page
11.
The tempo is displayed using the corresponding LEDs for every SPEED
control. With every commencing new wave-form-cycle, the LED will be lit.
Modulator 1
Modulator 2
180°
Owner's Manual VERMONA Retroverb Lancet
- 10 -