Vortech Ford Driver's Side Renegade System - Manual (Page 12)

P/N: 007062
©2003 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN03 v2.0
(DS Rngde S/C Sys(7062 v2.0))
6
8. SUPERCHARGER/ACCESSORY DRIVE BELTS, Cont'd.
Fig. 8-a
C. Fit the supercharger drive belt over the new
crank pulley and supercharger pulley.
D. Make sure the 1/2-20 jam nut previously
threaded onto the tensioner arbor is threaded
down almost all of the way, but not tight. The
belt is tightened/loosened by rotating the
belt tensioner adjustment screw. Tighten
the belt until light resistance is felt in the belt
tensioner adjustment screw. Proper belt ten-
sion is achieved when the belt can be twisted
approximately 1/4 of a turn by hand. Adjust
belt tension as needed. Do not over tension
the belt.
E. Tighten the 1/2-20 jam nut on the belt
tensioner arbor.
OPTIONAL IDLER
BYPASSED WATER
PUMP BELT ROUTING
STANDARD BELT
ROUTING (USING THE
SUPPLIED BELT TO DRIVE
WATER PUMP)