Vortech 1996-1998 Ford 4.6L Mustang Cobra - Manual (Page 22)

P/N: 4FK020-010
©2008 Vortech Engineering, LLC.
All Rights Reserved, Intl. Copr. Secured
24NOV08 v3.0(4.6L DOHC Cobra (4FK v3.0))
12
H. Following Figs. 7-d & 7-e, attach the supercharg-
er/aluminum bracket assembly with the Vortech
idler pulley and idler spacer to the alternator stud
and front cover using the supplied 8mm hardware.
Route the new, longer belt around the outside of
the supercharger drive pulley, then around the
inside of the Vortech idler. Finish routing the belt
around all of the pulleys, except for the water
pump. Make sure that the Vortech idler pulley
and spacer (located against the alternator base),
are seated and located in their proper position
before tightening down the bolts (see Fig. 7-g
for belt routing).
1996 - 1997 moDels oNly
NOTE: Make sure that a non-flanged water pump
pulley is installed on the vehicle. See note
at the beginning of this manual.
Fig. 7-e
7. MAIN BRACKET ASSEMBLY/DRIVE BELT, cont’d.
Fig. 7-d