Dish Network DISH 811 - Manual (Page 7)

7
4. Use the number buttons to enter any number
from 1 to 16. The SAT mode button goes out after you enter
each digit, and then lights up again.
Write down the number you entered:
5. Press the POUND (#) button.
If you entered the address correctly, the SAT mode
button will flash three times.
6. Press the RECORD button. If you are using a 6.0
remote with the green 1 key (no UHF Pro marking),
you must point the remote control at the receiver
while pressing the RECORD button.
7. Make sure the System Information screen shows the correct
remote address as follows:
• If only one Remote Address is shown, make sure this
address matches the number you entered in step 5.
• If you are using 6.0 remote with the green 1 UHF Pro key,
make sure that the Primary Remote Address shows
UHF Pro and IR and that this address matches the number
you entered in step 4.
• If you are using 6.0 remote with the green 1 key (with no
UHF Pro marking), make sure that the Primary Remote
Address shows
IR and that this address matches the
number you entered in step 4.
• If you are using 6.0 remote with the blue 2 UHF Pro key,
make sure that the Secondary Remote Address matches
the number you entered in step 4.
8. Close the System Information screen. On most receivers,
this is done by selecting the Done button. See your receiver
user's guide for more information.
text_dishpvr.fm Page 7 Tuesday, March 2, 2004 12:35 PM