Vortech 1987-1997 Ford 7.5L Truck/SUV - Manual (Page 6)

P/N: 4FB020-010
©2001 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
27JUL01 V1.1
(7.5 Ford 460(4FB V1.1))
Before beginning this installation, please read through this entire instruction booklet and the Street
Supercharger System Owner's Manual which includes the Limited Warranty Program and the Warranty
Registration form and return envelope.
Vortech supercharger systems are performance improving devices. In most cases, increases in torque of 30-35%
and horsepower of 35-45% can be expected with the boost levels specified by Vortech Engineering. This product
is intended for use on healthy, well maintained engines. Installation on a worn-out or damaged engine is not
recommended and may result in failure of the engine as well as the supercharger. Vortech Engineering is not
responsible for engine damage.
Installation on new vehicles will not harm or adversely affect the break-in period so long as factory break-in
procedures are followed.
For best performance and continued durability, please take note of the following key points:
1.
Use only premium grade fuel 92 octane or higher (R+M/2).
2. The engine must have stock compression ratio.
3. If the engine has been modified in any way, check with Vortech prior to using this product.
4. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until problem is
resolved.
5. Perform an oil and filter change upon completion of this installation and prior to test driving your vehicle.
Thereafter, always use a high grade SF rated engine oil or a high quality synthetic, and change the oil and
filter at least every 3,000 miles. Never attempt to extend the oil change interval beyond 3,000 miles,
regardless of oil manufacturer's claims as potential damage to the supercharger may result.
6. Before beginning installation, replace all spark plugs that are older than 1 year or 10,000 miles with original
heat range plugs as specified by the manufacturer and reset timing to factory specifications (follow the
procedures indicated within the factory repair manual and/or as indicated on the factory underhood emissions
tag). Do not use platinum spark plugs unless they are original equipment. Change spark plugs every
15,000 miles and spark plug wires at least every 50,000 miles.
TOOL & SUPPLY REQUIREMENTS
• 3/8" socket and drive set
• Flat #2 screw driver
• Large screw driver or pry bar
• Adjustable wrench
• 3/8" open end wrench
• 7/16" open end wrench
• 1/2" open end wrench
• 9/16" open end wrench
• 9/16" drill bit
• 3/32" drill bit
• Drill motor
• 3/8" NPT tap and handle
• 1-1/16" six point socket and drive set
• Ford Snaplock fuel fitting disconnect tool
• Teflon sealing tape or paste
If your vehicle has in excess of 10,000 miles since its last spark plug change, then you will also need:
• Spark plug socket
• NEW spark plugs
Congratulations on selecting the best performing and best backed automotive
supercharger available today... the VORTECH ® V-2 ® Supercharger!
Part No. 4FB218-040SQ
’86-’97 7.5L F-Series Truck
- 50 State Smog Legal per CARB EO #D-213-17
Installation Instructions for
vi