Vortech 1988-1992 5.0L/5.7L TPI F-Body - Manual (Page 11)

P/N: 4GF020-010
©2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
12JAN01 V1.1 (88-92 350 TPI Camaro(4GF V1.1))
1. COMPONENT REMOVAL
A. Disconnect the battery (negative lead).
B. Remove and set aside the following compo-
nents:
• Air inlet bellows
• Air filter cover assembly and elements and
the panel below filter
• Windshield washer reservoir
• Accessory drive belt
• Crankshaft pulley
• Alternator (disconnect wiring)
• Power steering pump pulley (use puller)
• Power steering pump and bracket (DO NOT
disconnect lines)
• Power steering bracket
2. CRANKSHAFT PULLEY INSTALLATION
A. Remove the crankshaft pulley from the engine if
not already done.
B. Place the Vortech provided crank pulley spacer
and crank pulley inside the stock pulley.
C. Line up bolt holes and, if necessary, press
pieces together.
D. Reinstall the pulleys as a unit onto the crank-
shaft balancer assembly using three 3/8-16 x 2
3/4" bolts and one 7/16-20 x 4" center bolt.
1
3 BOLTS: 3/8-24 x 2-3/4"
SPACER NEW ADDITIONAL PULLEY
CENTER BOLT: 7/16-20 x 4-1/4"