Vortech 1993-1997 5.7L LT1 F-Body - Manual (Page 6)

P/N: 4GH020-010
©2003 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
05NOV01 v1.2
(4GH V1.2)
vi
1994-95 GM LT1 F-BODY SUPPLEMENT
HARDWIRING INSTRUCTIONS FOR KITS NOT
EQUIPPED WITH A GM WIRING HARNESS
1. Unplug the grey and black connectors from the coil.
Cut the connectors off from the main harness
approximately 2" from the end.
2. Attach the supplied male and female connectors to
lengthen the white and pink wires previously cut from
the coil connectors. Connect the two pink wires
together to one red wire. Attach the pink and white
wires to the red and white wires on the supplied ignition
box.
3. Reattach the grey connector to the coil (leave the black
connector disconnected). Using the supplied male and
female connectors, attach the pink wire on the grey
connector to the orange wire on the supplied ignition
box and attach the white wire to the black wire on the
ignition box.
PINK
HEAVY RED
HEAVY BLACK
TO BATTERY +
TO GROUND
FACTORY GM
HARNESS
(UNPLUGGED
FROM COIL)
IGNITION COIL
NO CONNECTIONS
AT BLACK TERMINAL
GREY
TERMINAL
PINK
ORANGE
WHITE
BLACK
GREY CONNECTOR
BLACK CONNECTOR PINK
WHITE
RED
RED
WHITE
CUT
HERE X
X
X
WIRE TAP
RED
WHITE
BLACK
ORANGE
GREEN TACH (TAPE UP)
*GREY MAGNETIC TRIGGER HARNESS (TAPE UP)
YELLOW (TAPE UP)
BLACK (GROUND) BROWN WITH WHITE STRIPE RED
SUPPLIED MAP SENSOR
MANIFOLD
VACUUM
3 WIRE HARNESS RANE C
ELECTRONICS
HI-6TR
TIMING RETARD CONTROL
R ETARD
C RANE
cams ®
HI-6R
CAPACITIVE DISCHARGE IGNITION
WITH AUTO-SEQUENCE REV LIMITER
*NOTE: CABLE CONTAINS RED AND BLACK
LEADS. MAKE SURE LEADS DO NOT CONTACT
EACH OTHER AND SHORT UNIT WHEN TAPING UP.