Vortech 1999-2001 Ford 6.8L Super Duty - Manual (Page 7)

P/N: 8N020-100
©2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28MAR02 V1.0 (99-01SDPwrCoolr(8N020-100V1.0)
1
A. Remove the supercharger drive belt.
B. Remove the entire air inlet assembly. (MAF
bracket, flex hose and aluminum inlet tube.)
C. Disconnect the flex hose from the MAF (Mass
Air Flow meter) and remove the MAF bracket
from the vehicle with the attached meter.
D. NOTE: If your standard supercharger system
has a Gen. I MAF bracket you will need to
remove the MAF meter from the MAF bracket.
(See
Fig. 1-a.) It will be installed on the supplied
Gen. II MAF bracket in step 5, air inlet assembly.
E. Remove the aluminum discharge duct.
F. Disconnect the oil feed and oil drain lines from
the supercharger. Cap to prevent debris from
entering the open lines.
G. Remove the supercharger from the mounting
plates.
H. If your vehicle has gone over 30,000 miles since
its last spark plug change you will need to
change the spark plugs.
1. PREPARATION / REMOVAL
GEN I MAF
BRACKET
ASSEMBLY
GEN II MAF
BRACKET
ASSEMBLY
Fig. 1-a