WebDT DT160 - Manual (Page 2)

DT160
ENGLISH 2 3 ENGLISH
THE DT160
Rear View Front View
Powering ON and OFF
The Power Button is located in the front of the DT160. The Power Button may be configured to
behave differently depending on the operating software. In general, to turn the DT160 on, push
and release the Power Button on the front bezel. The adjacent power LED will be lit (blue) and the
corresponding interface will be displayed on the display monitor.
To turn off the device, again depending on software operating system, push and release the Power
Button or use a software shutdown interface.
In the event of system lockup, the Power Button may be used to perform a reset on the device. To
do that, push and hold the Power Button for at least 4 seconds. The system will shut down and all
unsaved work may be lost. Pushing on the Power Button again will restart the device.
Device Ports
The DT160 features an optimal set of I/O ports while preserving the compact size of the structure.
The DVI, Network (10/100 BaseT Ethernet), and Power ports are supplemented by a set of four USB
2.0 and three Audio ports.
Through its USB ports, the DT160 supports a wide range of USB-based peripherals. These
peripherals are applicable in providing the means for software installation, application storage, data
storage, and system software recovery and updates.
Memory and Storage
The DT160 may be available in storage configurations ranging from 4GB to 16GB of flash memory.
Depending on base software configuration, the user may use the internal flash memory of the
DT160 for user’s installed software and storage. The user may also supplement storage space with
USB-based peripherals such as flash disks, disk drives, etc. RAM capacity is 1GB.
Options
The DT160 is designed to work with a range of custom and off-the-shelf options to enhance its
applicability for various deployments.
USB-to-Serial and USB-to-PS/2 adapters •
Internal mini-PCI wireless LAN (WLAN) adapters •
Short DVI cable for connection to mounted display •
External bracket for mounting the DT160 to VESA adapters and •
LCD monitors (see mounting process below)
It is quite simple to mount the DT160 to VESA adapters or LCD monitors using the external
mounting bracket.
Precautions
Always exercise care when operating and handling the DT160. •
Never disassemble any portion of the enclosure. It will void any product warranty on the DT160. •
Do not use any AC/DC adapter other than the one provided with the device or acquired from the •
manufacturer or its partners.
In the unlikely event that smoke, abnormal noise, or strange odor is present, immediately power •
down the DT160 and disconnect all power sources. Please report the problem to your device
provider immediately.
USB 2.0 (2)
Ethernet port
DVI-I port
DC-in E
G
F
H
A
A
B
C
C
D E F G H
D
B
Audio jacks
Power indicator
Power button
USB 2.0 (2)