WebDT DT180T - Manual (Page 2)

DT180P
ENGLISH 2 3 ENGLISH
THE DT180P
Powering ON and OFF
The Power Button is located in the front of the DT180P. The Power Button may be configured to
function differently depending on the power options of the operating system. In general, to turn the
DT180P on, push and release the Power Button on the front bezel. The adjacent power LED will be
lit (blue) and the corresponding interface will be displayed on the display monitor.
To turn off the device, again depending on software operating system, push and release the Power
Button or use a software shutdown interface. In the event of system lockup, the Power Button may
be used to perform a reset on the device. To do that, push and hold the Power Button for at least 4
seconds. The system will shut down and all unsaved work may be lost. Pushing on the Power Button
again will restart the device.
Device Ports
The DT180P features an optimal set of I/O ports while preserving the compact size of the system.
The HDMI connector, Network (10/100/1000 BaseT Ethernet), and Power ports are supplemented
by a set of two USB 2.0 and two Audio ports. Through its USB ports, the DT180P supports a wide
range of USB-based peripherals. These peripherals are applicable in providing the means for
software installation, application storage, data storage, and system software recovery and updates.
Memory and Storage
The DT180P may be available in storage configurations ranging 8GB of flash memory or 32GB to
64GB SSD. Depending on base software configuration, the user may use the internal memory of the
DT180P for user’s installed software and storage. The user may also supplement storage space with
USB-based peripherals such as flash disks, disk drives, etc. RAM capacity is up to 2GB.
VESA Mounting Bracket Installation Guide for DT180P
The DT180P package includes a VESA-compliant mounting bracket (1) which mounts the DT180P (2)
onto a VESA-compatible monitor or display.
NOTE: The VESA Mounting Bracket is compatible with most displays and monitors that support the VESA standard.
Precautions
Always exercise care when operating and handling the DT180P. •
Never disassemble any portion of the enclosure. It will void any product warranty on the DT180P. •
Do not use any AC/DC adapter other than the one provided with the device or acquired from the •
manufacturer or its partners.
In the unlikely event that smoke, abnormal noise, or strange odor is present, immediately power •
down the DT180P and disconnect all power sources.
Please report the problem to your device provider immediately. •
Rear View Front View
A B C D F E G H
Ethernet port
HDMI port
VGA port RS232 COM port
DC-in D
F
E
G
H
A
B
C
Audio jacks
Power button
USB 2.0 (2)
Step1:
Locate the existing mounting holes on •
the monitor.
Line the bracket holes up with the holes
•
on the back of the monitor, as shown
to the right.
Place the screws to hold the mounting
•
bracket in place and tighten the screws
(do not over-tighten).
Step2:
Remove the two M3 screws (3) originally •
on the DT180P signage appliance.
Place the DT180P (2) on the bracket
•
rail with the interface ports side facing
downwards so that the two mounting
holes on the appliance are aligned
with the existing holes on the rail (see
picture).
Step3:
Apply and tighten the screws into •
their original locations and make
sure that the bracket and the
DT180P are properly secured.