Wharfedale Pro Programme 35ET - Manual (Page 9)

CONNECTIONS/ WIRING
Be sure to connect your speakers in proper polarity (what many refer to
erroneously, as phase). This means that in normal operation; connect one
end of the same wire to the Red terminal on the amplifier and the other end
to the Red connector on the speaker. Black is always the ground or common.
Because the Programme Series is so flexible, you can wire many speakers
in parallel or series or a combination of Series/Parallel. Follow the diagram
below for wiring schemes .
7
G G
B R
G G
B R
G G
B R
Series
Connection
Parallel
Connection
Normal
Connection
Programme Series 30E
/
35E
Wiring and setting up your Programme 30E/30ET/35E/35ET is as easy as
plugging in a household appliance. You simply run your speaker cables from
your amplifier to one of the parallel spring style input connectors on the Pro-
gramme 30E/30ET/35E/35ET input panel.
The Programme 30E/30ET/35E/35ET accept stripped bare end cables.
Attach the speaker cable securely to your Programme Series unit and power
amplifier (the amplifier should be off). Use the correct gauge of speaker cable
according to the power handling ability of your Programme Series cabinet.
Use stranded insulated cable for speaker runs. It is always advisable to use
heavier gauge (lower number) cables on longer runs.