Wharfedale Pro Programme Sub - Manual (Page 10)

OPERATING MANUAL AND USER GUIDE
CONNECTIONS/ WIRING
Wiring and setting up your Programme Series is as easy as plugging in a household
appliance. You simply run your speaker cables from your amplifier to one of the parallel
spring style input connectors or on the Programme Series input panel.
The Programme Series accept stripped bare end cables and SpeakOn™ connectors
(108/206/406). Attach the speaker cable securely to your Programme Series unit and power
amplifier (the amplifier should be off). Use the correct gauge of speaker cable according to
the power handling ability of your Programme Series cabinet. Use stranded insulated cable
for speaker runs. It is always advisable to use heavier gauge (lower number) cables on
longer runs.
Be sure to connect your speakers in proper polarity (what many refer to erroneously, as
phase). This means that in normal operation; connect one end of the same wire to the Red
terminal on the amplifier and the other end to the 8Ω (+) connector on the speaker. Black is
always the ground or common and should be connected to the 8Ω (-).
70V C
100V C
8 +) 8
30W 60W
60W
15W
30W
7.5W
15W N/C
LOW IMPEDANCE CONNECTION (T) MODELS
9