Wharfedale Pro CPD3600 - Manual (Page 5)

4
1. LIMITER LED: Illuminates when the amplifier is being driven into clipping.
2. SIGNAL LED: Indicates presence of signal on the channel.
3. PROTECT LED: Illuminates when the amplifier is in protect mode due to short circuit, over current or thermal overload.
4. POWER LED: Illuminates when the amplifier is connected to mains power and switched on.
5. Input Trim: Controls the output level of the amplifier.
6. Power switch: To power the amplifier up or down.
7. Air filter: Knocked down air filter cover. Easily for clean. The air flow is from front to back.
FRONT PANEL FEATURES AND CONTROLS
REAR PANEL – FEATURES AND CONTROLS
. XLR Input: Balanced XLR input for connection to 0dBu line level sources. CH INPUT is also the available input
channel for BRIDGE mode.
2. XLR link Output: Balanced XLR output to another CPD amplifier.
3. Mode Switch: There are 3 switchable operating modes, parallel, stereo and bridge.
4. LIMITER Switch: The internal limiter can prevent signal overload and distortion.
5. SPEAKON Output: For connection to passive loudspeakers.
6. Grounding Terminal: The grounding terminal for the chassis.
7. Mains Power Cord: The unit has a fixed power cord, and for the safety, this cord is not allowed to be replaced arbitrarily
by the user.
WARNING: DO NOT ATTEMPT TO BYPSS THE GROUND CONNECTION OF THE POWER CORD!
8. FUSE: Please use the same type fuse as the text of the chassis for replacing.
 2 3 4 5 6
2  3 4 5 6 7 8
7