Wharfedale Pro Force 12 - Manual (Page 10)

OPERATING MANUAL AND USER GUIDE
8
FORCE 12 MASTER SECTION
Peak LED-----Illuminates when the Effects clipping
LED Digital Display -----56 sorts of stereo effects can be displayed via LED digital display
FX Send-----Allows for master adjustment of the FX send bus.
FX Select-----Selects the effect type.
FX to Mon-----Routes the FX processor output to the Monitor send.
FX to Mix-----Controls the output level of the internal FX processor to the master buss.
7-band EQ
-----Dual 7-band graphic equalizers with fixable A/B EQ Routing.
Bypass-----Used to switch the internal FX processor on or off.
Power LED-----Indicates the main power supply.
Phantom Power LED-----Indicates +48v phantom power supplied to all of the Mic inputs. Please check
that all connected microphones can withstand +48v power input.
Master Level LEDs----Dual 8 Segment LED metering for the master. If the limit LED illuminates
constantly lower the master level to avoid damage to your loudspeakers.
EQ Routing Switch----
- Configures the signal routing of the graphic EQs. In the Mode “A”, each EQ
controls the respective output with monitor sends routed unprocessed to the Mon output. In the Mode “B”,
the Mon is processed by the EQ2, and the EQ1 will process both left and right output channels.
Mute Button
----- Mute/un-mute all the Mic Channels (CH1-8).
Mon-----Controls the gain to the Mon-send, and also controls the AMP 2 if the EQ Routing switch is
setting to “B”
Mix -----Controls the gain to the Main L/R and also controls the AMP 1 and AMP 2 at the same time if the
EQ Routing switch is setting to “A”, but only controls the AMP 1 if the EQ Routing switch is setting to “B”
1 2
3
4
5
6
14 15
13
12
11
10
9
7
8
1
2
4
5
6
7
8
9
10
11
12
13
14
15
3