Wharfedale Pro Contact 502A - Manual (Page 9)

8
Contact 502A
SETTING UP THE RECEIVER
Output connection:
1. Install the two antennas on the rear panel as shown in
Fig.3a.
2. Connect the power supply as shown in Fig.3. (Caution:
Ensure the power supply has the correct rating for your
local AC supply)
3. Connect audio leads from the output of each channel
to an input on a mixer or powered speaker. When the
output cable is connected to an auxiliary or line input
the “OUTPUT LEVEL” switch (16) should be set to the
“LINE” position. When the output cable is connected to
a microphone input of a mixer or powered loudspeaker
the “OUTPUT LEVEL” switch should be set to the
“MIC” position. If the “LEVEL” switch is set in the wrong
position the gain structure will be wrong and can cause
excessive hiss or distortion.
4. When the “OUTPUT MODE” switch (14) is set to “MIXED”
only connect to “OUTPUT A” (13). There is no output
from “OUTPUT B” in this mode.
Fig.3
Fig.3a