Operating your tv – Daewoo DTQ 25S2FCV User Manual
Page 13
Chapter 3 : Operating Your TV
Operating Your TV
C H A P T E R
3
10
Once you have connected your TV to an antenna or cable system, plugged the TV in,
and put batteries in the remote, you are ready to use the TV. The first thing you should
do is program your TV so it memorizes all of the available channels.
Turning Your TV On
1
To turn your TV on, press the POWER button on the remote
control. You can also use the POWER button on the front panel.
Make sure your TV is plugged in before you try to turn it on.
Programming Your TV's Channel Memory
Your TV's memory determines the channels that are available using the
V
CH
W
buttons. If a channel is not in memory, you can tune to it with the number buttons, but
not with the
V
CH
W
buttons. Follow these steps to program your TV's memory:
1
With the TV on, press the MENU button.
2
Use the
V
CH
W
buttons to select SETUP and press
C
VOL
B
.
3
Use the
V
CH
W
buttons to select ANTENNA, then use the
C
VOL
B
buttons to
select AIR or CABLE. If you connected an antenna to your TV, select AIR; if you
connected a cable system, select CABLE.
4
Use the
V
CH
W
buttons to select AUTO PROGRAM, then use the
C
VOL
B
but-
tons to begin the AUTO PROGRAM process. This process takes a few minutes.
5
Press the MENU button to return to normal TV viewing.
Your TV's channel memory will not be affected by a power outage. You will not need to
re-program the memory unless you change the type of cable antenna connected to your
TV.
2
3
4
1
1