Wyred 4 Sound mAMP - Manual (Page 5)

pg. 3
sufficient control of your speaker to ensure tight bass as well as a powerful yet
nimble sound stage. The mono-block form factor allows you to use a short speaker
cable for each channel by placing the amp in near proximity to each speaker. A
mono-block configuration can cut cost on speaker cable while improving the
performance of your system. Another benefit of separate amps is the elimination of
channel crosstalk which further improves the imaging and presence of a well
designed product.
Finally, the part that makes all of this possible is what many have been
waiting for! The new chassis is even more attractive than ever and still keeps the
functionality that we have come to love. A front view of the unit reveals only two
screws tucked neatly in the rear of the top cover. The front panel is meticulously
machined from a solid piece of ¾” aluminum, line grained, and anodized in black. A
radius on either side of the front panel rounds the corners off elegantly where the
side extrusions extend to the rear of the unit and bare the same high quality
anodized finish. The top cover is available in clear anodize (Silver) or black and has
stylish venting allowing heat to escape. Having a structure with so much forward
thinking creates a product that is very rigid and immune to frequencies and
vibrations which can be generated by the various components in a HiFi system.
AC Mains Voltage switch
Located on the left side of the rear panel is an AC mains switch. When
changing the 2 position slider switch the mAMP will need to be unplugged and
powered down for at least 2 minutes. It is very important to ensure that the slide
switch is in the proper position before applying power. Failure to do so will likely
result in damaging the internal components and will not be covered under
warranty.
The fuse is located above the IEC plug on the rear of the unit. It can be
inspected by sliding the fuse holder out (It has a symbol of a fuse on it).
Fuse size 5x20mm Slow Blow / T5A 250VAC