Genie Pro max PMX-IC B Series - Manual (Page 21)

1. Disconnect the power cord from the branch
circuit mains.
2. Remove bottom cover from power head.
•
Remove four (4) hex head screws from front
and rear covers.
•
Slide bottom cover off.
3. Remove existing power cord from power head.
•
Disconnect three power cord wires.
•
Remove and discard power cord.
•
Remove 7/8
”
diameter knock-out plug.
•
Install a suitable entrance bushing.
4. Install permanent wiring to power head.
For Stealth—connect permanent wiring to
internal terminal block.
•
Connect white supply line to silver terminal.
•
Connect black supply line to brass terminal.
•
Connect ground wire to green wire location
(GROUND).
For ProMax—connect permanent wiring.
•
Make connections with UL recognized wire nuts.
•
Connect white supply line to white wire.
•
Connect black supply line to black wire.
•
Connect ground wire to green wire location
(GROUND).
•
Wires inside operator are to be a minimum of
6 inches.
5. Replace power head bottom cover.
•
Replace and tighten four (4) hex head screws.
NNOOTTEE:::: CCiirrccccuuiitttt bbbbooaarrrddddsss aarree llliiggghhhhttt sseennssiiiittiivvee.. MMaakkkkee ssuurrrreeee
ccoovveerr iissss oonn ppoowweeeerr hheeaaaadd bbeeffffooorrreeee ooooppppeerraaaattiioooonnnn..
1. Check local building codes.
•
Some building codes require direct wiring to a
branch circuit. If direct wiring is NOT required,
plug door operator into grounded outlet
(Fig. 6-1) .
2. Return to Section 3 for SAFE-T-BEAM
®
System
alignment and troubleshooting.
NNOOTTEE::: IIffff ppppeeeerrmmaannnneeeenntt wwiirrrriiiinngg iiss rreeqquuiirrrreeeedd,, hhhaaavvee aaa
pprrooffeessssssiioooonnnnaaaall eelleeccccttrriicciiiiaann iinnnnssssttaallllll cciirrrrcccuuiittt aannnddd wwiirrreeee
ddoooorr ooppeerraattoorr...
Fig. 5-1
Operator
power cord
Grounded
outlet
To reduce the risk of electrical shock, this equipment
has a grounding type plug that has a third
(grounding) pin.This plug will only fit into a grounding
type outlet. If the plug does not fit into the outlet,
contact a qualified electrician to install the proper
outlet. Do Not change the plug in any way.The door
operator must be properly grounded to prevent
personal injury and damage to the components.
The ELECTRICAL POWER to the door operator
MUST BE TURNED OFF when power head cover is
removed. Electrical power must remain off while mak-
ing electrical connections.
55
.......
CCOONNNNNEECCCTTTT OOOOPPEEEERRAATTOORRR TTOOOO PPPPOOWWWWEEEERR
FFOOR HELLP--1.8000.3354.36443 OOR GGENIECOMPANY.COM
21
PPPPEERRMMAAAANNNNEEEENNTTT WWWWIIIIRRIIINNGGG
INNSTRRUCTTIONSS FOOR ELEECCTRIICIIAN
WARNING