Ryobi RY141600 - Manual

991000343
12-22-14 (REV:01)
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to
the operator’s manual.
FIRST TIME ASSEMBLY
RY141600 QUICK REFERENCE GUIDE
STARTING THE UNIT USING DETERGENT
Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is
ready for operation (see page 11).
1
2
When finished, press switch OFF to stop the motor (see page 12). 3
Press switch ON to start the motor (see page 11).
NOZZLE SELECTION GUIDE
Use of soap nozzle will activate detergent injector at a 20:1 dilution ratio.
WARNING! Never use bleach or solvent-based detergent.
• Will damage your pump
• Will void your warranty
• Will damage plants/shrubs
Use the chart below to determine the correct nozzle for your job.
2 Install blue or black soap
nozzle (see page 13).
1 Pour pressure washer
detergent in soap tank (see
page 13).
3 Squeeze trigger and wait
approx. 5 seconds for soap
(see page 13).
SWITCH
ON
If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet
(see pages 3 and 8).
SWITCH
OFF
BEFORE STORING THE UNIT
Always add Pump Protector to the unit after each use and before storing. This will significantly im-
prove pump life. (See page 14.)
Pump protector is available from your local retailer. For further assistance, call customer service at
1-800-860-4050.
To add, follow the instructions provided by the Pump Protector manufacturer.
1
PUMP
PROTECTOR
Make the most of your purchase! Go to www.ryobitools.com
and register your new tool online. For questions about operating
or maintaining your product please call, 1-800-860-4050.
HIGH PRESSURE
(NO SOAP WHEN USING
THESE NOZZLES)
LOW
PRESSURE
(FOR SOAP OR
GENTLE RINSE)
Turbo Nozzle 15º Blue or Black
Soap Nozzle
Concrete, Brick, Masonry
  
Siding, Gutters, House
 
Fencing, Deck, Patio
 
Lawn Equipment, Boat, RV
 
 Recommended Nozzle
 Use With Caution for Certain Applications
Connect the spray wand to the trigger handle
(see page 10).
Connect the high pressure hose to the pump (see
page 10).
Connect the high pressure hose to the trigger
handle (see page 10).
Connect the garden hose to the pump (see page
10).
1 3
2
4
Completely uncoil garden hose or remove
completely from reel to prevent kinks.
Turn water faucet on fully.
Make sure there are no leaks.
With no nozzle installed, squeeze the trigger
to relieve air pressure. Hold the trigger until
a steady stream of water appears.
5 S
USE ONLY THIS SIZE EXTENSION CORD WHEN
USING THIS PRODUCT:
Cord Length Wire Size (A.W.G.)
25 ft. 14
50 ft. 12
100 ft. Not Allowed
NOTE: A.W.G. = American Wire Gauge
25
DETERGENT