Ryobi SC164VS - Manual (Page 21)

21
TROUBLESHOOTING
Motor will not run.
Blades breaking.
Vibration
(there is always some vibration
when the saw is running).
Blade runout (blade not properly
aligned with arm motion).
PROBLEM CAUSE SOLUTION
1. Problem with ON-OFF switch,
power cord, or outlet.
2. Motor defective.
1. Too much tension.
2. Feeding too quickly.
3. Wrong blade.
4. Blade twisting in wood.
1. Improper mounting of saw.
2. Mounting surface.
3. Loose table or table resting
against motor.
4. Loose motor mounting.
1. Blade holders out of line.
1. Have worn parts replaced before using
scroll saw again. Have the proper outlet
installed by a qualified electrician.
2. Do not attempt any repair. Have repaired
by a qualified service
technician.
1. Adjust tension.
2. Reduce feed rate.
3. Narrow blades for cutting thin wood or
tight corners and turns, wide blades for
thicker wood or wide turns.
4. Reduce side pressure on blade; check
blade tension.
1. Check mounting.
2. Check mounting in manual.
3. Tighten table lock knob.
4. Tighten mounting screws.
1. Realign blade.