Ryobi RY28000 - Manual

ENGINE STARTING PROCEDURE
RYOBI ART WORK
Art Part No. : 987000849 Rev. 001
Where Used : 987000849
Refer to Drawings for Dimensions.
987000-849
9-14-09 (REV:01)
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
PRESS and HOLD switch until
engine stops.
To Stop:
For any questions about operating or maintaining your product, call the Ryobi Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-860-4050
www.ry
obitool
s.com
®
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
1
6
4
2
3 5
7
1
Set to " HALF CHOKE ".
50:1 Ratio = Mix 2.6 oz 2-cycle oil with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
Slowly press the PRIMER BULB 10x.
Set to "FULL CHOKE".
SQUEEZE THROTTLE TRIGGER FULLY and pull
starter grip until engine runs (no more than 6x).
NOTE: If engine does not start, return to step 3 and repeat.
SQUEEZE THROTTLE TRIGGER FULLY and pull
starter grip sharply until engine attempts
to run (no more than 4x).
1 GALLON
GAS
2
3
4
5
6
7
Allow engine to run 10 seconds, set to " RUN ".
10x
FULL
CHOKE
HALF
CHOKE
RUN
2.6
oz.