Ryobi RTS20 - Manual (Page 16)

16
ASSEMBLY
MOUNTING THE TABLE SAW BASE TO THE
QUICK STAND™
See Figure 8.

Place the table saw base on the leg stand. Position the
locking knob over the holes in the top of the leg stand.
 Insert the screw on the locking knob into the hole and
turn the locking knob clockwise to secure the table saw
base to the leg stand.
 Repeat with the other three locking knobs.
TO INSTALL THE HANDLE
See Figure 9.

Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle.

Place the nylon nut into the recessed hole on the back
of the height/bevel adjusting handwheel and hold in
place.
 Slide the handle and screw into the hole on the height/
bevel adjusting handwheel.
 Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
Fig. 8
LOCKING
KNOB
HOLE
Fig. 9
HANDLE
SCREW
NUT
HEIGHT/BEVEL
ADJUSTING HANDWHEEL
Fig. 7
Fig. 6
V SLOT
RED
INDICATOR