Driverack, Getting started – dbx Pro 4800 User Manual
Page 14
Getting Started
®
4
Section 1
O
OU
UT
TP
PU
UT
T is used to select and/or enter the Input and Output setup module.
R
RO
OU
UT
TE
E//M
MIIX
X is used to select and/or enter either the Input or Output Router or Mixer
module.
IIN
NSSE
ER
RT
T 1
1 is used to select and/or enter the first Insert function in either the Input or
Output.
IIN
NSSE
ER
RT
T 2
2 is used to select and/or enter the second Insert function in either the
Input or Output.
D
DE
EL
LA
AY
Y is used to select and/or enter either the Input or Output Delay module.
P
PR
RE
ESSE
ET
T is used to return to the Preset Screen and exit out of any mode. Pressing and
holding PRESET enters Preset Recall Mode allowing selection of an alternate preset.
SST
TO
OR
RE
E is used to store any preset changes. Pressing and holding STORE lets you
Delete a preset from the preset table.
U
UT
TIIL
LIIT
TY
Y is used to access the Utility menu. Pressing and holding UTILITY allows access
to the Meter Mode where additional metering is available.
W
WIIZ
ZA
AR
RD
D is used to enter the Wizard section. Pressing and holding the WIZARD button enters
Configuration Mode where changes to the preset configuration can be made.
R
RT
TA
A is used to view the Real Time Analyzer. In other modes (such as Preset Recall or
Configuration) pressing and holding the RTA button is used to Load those changes.
3. Input Channel Select A-D
These buttons are used to select the desired input channel.
4. Ouput Channel Select 1-8
These buttons are used to select the desired output channel.
5.Threshold Meters
The tri-color Threshold meters indicate that the threshold level has been exceeded in the Output Insert
Limiter, Compressor or Auto Gain Control.
6. RTA Input Jack
This balanced XLR input is used for the connection of an RTA microphone, which may be used with
the Auto EQ Wizard and RTA functions. 48V phantom power is always engaged on this connector.
7. Parameter Control 1-3
These three knobs are used to select and edit parameters.
8. Input Meters
The DriveRack 4800 provides you with four independent eight segment input headroom meters that
range from SIG (-48dB) to 0dB. These meters monitor the signal directly following the input section.
DriveRack
®
DriveRack
®
4800/4820 User Manual