D-Link DCS-1000W - Manual (Page 79)

79
I/O Schematic Diagram
Warning
1. When connecting a device to the Input connector, the device must be a passive
component without voltage and electrical current.
2. When connecting other devices through the Output connector, please make
sure the maximum current of DC 5V, 100mA is strictly observed.
3. Any failure of the above two points might cause serious damage to the camera.
Note:
Through the Web Configuration in the Trigger section, you must first enable
the trigger function. Please refer to the Web Configuration section for de-
tailed information.
voltage 5V.
voltage 5V.