Dometic RM36O - Manual (Page 8)

a
CABINET ADJUSTMENTS
To change door panel
The refrigerator is normally delivered without door
panel(s). Before starting the mounting work check
that the panel dimensions are in compliance with
those given in the table and read the instructions
through. When mounting the panel, proceed as follows:
1.
2.
3.
4.
5.
6.
Remove the top decoration strip (2) with
two screws (1).
its
Insert one of the vertical edges of the p anel
into the groove of the door frame (3).
Bend the panel gently so that the free side of
the panel can be slipped into the corresponding
groove of the door frame (4).
Push the panel downwards so that the lower hori-
zontal edge of the panel is fitted into the
bottom groove (5).
Between the upper edge of the panel and the door
frame there is now a gap which should be covered
by the decoration strip.
Put the strip across the door so that the gap
is covered and push it upwards (6).
The tabs on the inside of the strip should fit
in behind the flange of the door frame. Secure
the decoration strip by means of the two screws (1).
Panel dimensions
Thickness max. 5/32"
Height Width
Type Max. Min. Max. Min.
RM 360 636 633 516,5 513,5 m m
25" 24 7/8" 20 11/32" 20 7/32"inch
RM 460 679 676
26 23/32"
550,5 547,5
26 19/32" 21 11/16" 21
RM 660 879 876 550,5 547,5 m m
34 5/8" 34 l/2" 21 11/16" 21 9/16"inch
RM 760 288 285 550,5 547,5 m m
upper 11 11/32"
11 7/32" 21 11/16" 21 9/16"inch
RM 760 801 798 550,5 547,5 m m
lower 31 17/32" 31 13/32" 21 11/16" 21 9/16"inch
Fig.8