Nexen 5H100PSE-E 913108 - Manual (Page 2)

2
FORM NO. L-20288-A-1199
SPECIFICATIONS
The 5H Spring Engaged Multiposition Tooth Clutches has a
drive flange with a single bearing and tapped mounting holes.
The 5H Series has a Drive Flange with two bearings, a pilot diameter, and tapped holes for mounting a pulley, sprocket,
gear, or coupling adapter (See Table 1).
PRODUCT NO. MODEL
ENGAGEMENT TORQUE
(In. Lbs.)
DISENGAGEMENT PRESSURE
(psi)
PILOT MOUNTED 913103 5H100PSE 43000 60
TABLE 1
INSTALLATION
1. Install coupling adapter or bearing supported pulley,
sheave, or gear.
2. Insert customer supplied key into shaft.
NOTE
Nexen Spring Engaged Multiposition Tooth Clutches
mount on a full shaft using a full length key.
NOTE
Whenever possible, arrange the input drive to the
Tooth Clutch through the drive flange to prevent the
Tooth Clutch bearings from rotating unnecessarily.
APPLICATION CONSIDERATIONS
1. This unit is not designed for use in cyclical applications.
2. Only engage this clutch at 0 rpm.
3. Do not exceed 80 psi.
4. Consult factory for operating speeds above 100 rpm.
3. Apply and adequate amount of Loctite ® 242 to evenly
coat the threads of the Set Screws.
4. Using the Set Screws, secure the Tooth Clutch to the
shaft.
5. Tighten the Set Screws.
In severe applications, the Tooth Clutch may tend to move
axially along the shaft. To prevent this movement, confine
the Tooth Clutch between its shoulders.