Dixon ZTRCLASSIC - Manual (Page 17)

17
CONTROLS
BLADE DRIVE:
• Located on the control panel, on the
operator’s right.
• To engage the mower blades, pull up on
the switch.
• To disengage mower blade, push down.
CIRCUIT BREAKER:
• Protection of the electrical system is by
(1) 15 amp circuit breaker.
• If circuit breaker trips, push button to
reset.
• If this condition repeats, consult dealer
for inspection and repair.
THROTTLE CONTROL LEVER:
•
Located on control panel to operator’s right.
• Throttle control for engine speed.
• Choke for engine starting.
• Throttle control should be set to MAXIMUM
or wide open setting to ensure adequate
cooling of the engine and to maintain mower
deck blade speed while mowing.
MOWER DECK LIFT LEVER:
•
Located to the right of the control levers.
• Controls the cutting height.
• Eight positions of adjustment.
• Move lever left and forward to lower.
• Move lever left and back to raise.
NOTE: Always use high for transport.