Amplifier connections, Xpe series installation – Dual XPE1700 User Manual

Page 7

Advertising
background image

7

XPE SERIES

 INSTALLATION

Amplifier Connections

Speaker Connections

Connect speaker wires observing
polarity. The minimum impedance
load for the XPE2700 and XPE4700
is 2 ohms stereo and 4 ohms
bridged. Use of loads lower than
these is not recommended and
may cause amplifier damage.
The XPE2700 and XPE4700 can
be wired for stereo, bridged or
stereo/bridged simultaneous
operation.

Input Signal Connections

Low Level Input (RCA)
Low level (RCA) input signal is preferred for best performance. Typical trunk-mount
amplifier installations require a 17-20 foot RCA cable. Most trucks and under-seat
applications require a 6-9 foot RCA cable. Using twisted pair construction RCA cables will
minimize noise.

High Level Input (Speaker Wire)
High level inputs should only
be used when RCA outputs are
not available from the head unit.
Connect the head unit speaker
outputs to the high level input
connector as shown below. The
black wire (signal reference ground)
may or may not require a connection
to chassis ground - depending on
your particular installation.

Subwoofer (mono)

Typical Bridged Wiring

(4 ohms minimum)

2 Speakers (stereo)

Typical Stereo Wiring

(2 ohms minimum)

CAUTION
Do not use both low and high level inputs at the same time - connect only one or the other.

XPE2700 speaker connections shown

Advertising
This manual is related to the following products: