D-Link DSL-500 - Manual (Page 43)

DSL-500 ADSL Router User’s Guide
Static Route Configuration
Use Static Routing to specify a route used for data traffic within your Ethernet LAN or to route data on the WAN.
This is used to specify that all packets destined for a particular network or subnet use a predetermined gateway.
The Existing Entry number tells you how many routes are currently configured. The Valid Entry number tells
you the number of routes that are enabled.
Figure 5 - 11. Static Route Configuration Table
The following variables must be defined for static route configuration is as follows:
Select index to set
When adding a new route, choose the Not selected option from the drop-
down menu first. This will automatically assign the next available index
number to the new route. If you are deleting or modifying an existing
route, select it and click the appropriate button to the right.
Item Name Name of the subnet or static route used.
State
Select Enabled to start using the static route when it is applied. To save a
route you do not want to use now for later use without deleting it you can
choose Disabled.
IP Address IP address of the subnet or device where packets are routed.
Subnet Mask Subnet mask that allows packets to be routed as intended.
Gateway IP address of the gateway used for this static route.
Interface
Choose Ethernet or select a WAN interface. If you have a single PVC and
have not modified the name of the WAN interface, it appears here as
ISP1 (the default name for the WAN interface).
Metric Maximum number of hops allowed for the static route.
To delete or modify an existing route, select the index number and click the action button for Delete or Modify.
Clicking on the Clear button will set the variables to the blank or default setting.
Each new route that is added will appear in the entry table at the top of the web page. When you have configured
all the routes you want to use, click on the Apply button. You can save and reboot the system now, or continue to
configure the Router.
33