Dish Network 32.0 - Manual (Page 22)

10
1 Make sure the UHF-2G remote antenna is connected to the correct
input on the receiver’s back panel and is not touching anything
else. It should be tightened only by hand. Note: Remote antennas
used with other DISH Network satellite receivers and remotes
cannot be used with your ViP922 receiver or remote controls.
2 Try varying the tilt angle of the receiver's remote antenna. Locate
the antenna’s tip away from any other electronic equipment or
metal surfaces, even if separated by wooden shelving.
3 Move the satellite receiver to a different location. For best results,
place the receiver on as high a surface as possible, above all other
equipment in your entertainment center.
4 Place the remote antenna away from other equipment by using the
optionally available special cable to connect it to the receiver.
5 Move any nearby antenna or radio equipment away from the
UHF-2G remote antenna. Do not place an over-the-air antenna,
WiFi, Bluetooth, or Zigbee devices on or near the remote antenna.
R EMOTE B UTTON S HORTCUTS
In addition to their normal functions, some buttons on your remote
control have special “shortcut” functions when you are navigating the
on-screen Electronic Program Guide (EPG), or inside a drop-down
menu of options or scrollable list of events displayed by your receiver.
DVR B UTTONS
The following table lists some of these shortcuts for the black set of
buttons that normally control your DVR functions. Note that scheduled
updates to your receiver software may add to or modify these shortcuts.
REMOTE BUTTON IN GUIDE DISPLAY SCROLLS IN LISTS
SKIP BACK Moves 3 Hours Back By 1 Screen Upward
PLAY/PAUSE Watch highlighted show No
SKIP FWD Moves 3 Hours Ahead By 1 Screen Downward
FAST REVERSE 24 Hours Back To beginning of list
FAST FWD 24 Hours Ahead To end of list