Oldsmobile 2001 Bravada - Manual (Page 73)

2-8
Your vehicle left the factory to have no doors lock and
none of the doors unlock. You can set the automatic
door lock feature to lock all the doors when the vehicle
speed is greater than 15 mph (24 km/h) for two seconds,
and then unlock the doors you select once the key is
removed from the ignition. The following instructions
detail how to program your door locks.
To enter the program mode you need to do
the following:
1. Begin with the ignition in OFF. Then pull the turn
signal/multifunction lever all the way toward you
and hold it there while you perform the next step.
2. Turn the key to RUN and OFF twice. Then, with the
key in OFF, release the turn signal/multifunction
lever. Once you do this, you will hear the lock switch
lock and unlock.
3. You are now ready to program the automatic door
locks. Select one of the four programming options
listed above, and follow the instructions. You will
have 30 seconds to begin programming. If you exceed
the 30 second limit, the locks will automatically lock
and unlock to indicate that you have left the program
mode. If this occurs, repeat the procedure beginning
with Step 1.
You can exit the program mode any time by turning
the ignition to RUN (the locks will automatically
lock and unlock to indicate that you are leaving the
program mode). If the lock/unlock switches are not
pressed while in the programming mode, the current
auto lock/unlock setting will not be modified.
See your dealer for more information.