NISSAN 2009 Rogue - Manual (Page 181)

Black plate (179,1)
Model "S35-D" EDITED: 2008/ 7/ 24
If the memo pad is full, the system asks if you
wish to record over the oldest memo.
“Delete”
*
C
The Delete command erases all memos. The
system asks you to confirm this action before
deleting all memos.
Setup
Use the Setup command to change options
associated with the Bluetooth
® Hands-Free
Phone System.
“Pair Phone”
*
A
Use the Pair Phone command to pair a phone to
the Bluetooth
® Hands-Free Phone System.
When you are asked to enter a PIN code for
pairing your Bluetooth
® cellular phone, operate it
to enter the code “1234”. The code is always
“1234” regardless of the number of phones
paired.
NOTE:
The pairing procedure must be performed
when the vehicle is stationary. If the
vehicle starts moving during the proce-
dure, the procedure will be cancelled. Also,
see “Pairing procedure” earlier in this
section for additional information.
Up to 5 phones can be paired. If you try to pair a
sixth phone, the system announces that you
must first delete one phone or replace an
existing phone.
If you try to pair a phone that has already been
paired to your vehicle’s system, the system
announces the name the phone is already using.
The pairing procedure will then be canceled.
When prompted by the system, choose from the
following commands:
. “New phone” — see “Pairing procedure”
earlier in this section.
. “Replace phone” — The system announces
the names of the phones already paired and
asks which you would like to replace.
Once you say the name of the phone you
wish to replace, the paring procedure will
begin. (See “Pairing procedure” earlier in
this section.)
. “List phone” — See the description below.
“List Phones”
*
B
Use the List Phones command to hear the
names of the phones currently paired. If no
phones are paired, the system announces, “No
paired phones to list.” The system then ends the
VR session.
“Select Phone”
*
C
Use the Select Phone command to select a
phone of lesser priority when two or more
phones paired with Bluetooth
® Hands-Free
Phone System are in the vehicle at the same
time.
The system asks you to name the phone and
confirm the selection.
Once the selection is confirmed, the selected
phone remains active until the ignition switch is
turned OFF or you select a new phone.
“Change Priority”
*
D
Use the Change Priority command to change
the priority level of the active phone.
The priority level determines which phone is
active when more than one paired Bluetooth
®
phone is in the vehicle.
The system states the priority level of the active
Heater, air conditioner, audio and phone systems 4-35