DeWalt D26411 - Manual (Page 8)

6
English
A. On/off switch E. Nozzle
B. Air vents F. Tool hanging ring
C. Kick-off stand G. Heat barrel cover
D. Air temperature adjustment knob
FIG.1
A
C
B
D
E
F
G
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and removing
accessories, before making any adjustments or removing/installing
attachments or accessories.
Setting the Air Temperature (Fig. 1)
The air temperature can be adjusted to suit a wide range
of applications. Turn the air temperature adjustment knob (D)
clockwise or counterclockwise for higher or lower heat. The table
below suggests settings for different applications.
Setting Applications
Low • Drying paint and varnish
• Removing stickers
• Waxing and dewaxing
• Drying wet timber prior to filling
• Shrinking PVC wrapping and insulation tubes
• Thawing frozen pipes
Medium • Welding plastics
• Bending plastic pipes and sheets
• Loosening rusted or tightly fastened
nuts and bolts
High • Removing paint and lacquer
• Soldering plumbing joints
ATTACH THE CORRECT ACCESSORY
This tool is supplied with a set of accessories for different
applications.
Icon Description Purpose
20
φ
Cone nozzle Welding, shrink sleeving
(heat concentrated over
small area)
50 mm Fish tail Drying, thawing
surface nozzle (heat spread
over wide area)
1. Make sure the on/off switch (A) is in position "O" and the tool
is disconnected from the power source. Ensure the nozzle has
cooled down.
2. Place the desired accessory onto the nozzle.