Operation – Audio Solutions TVAM2-1 User Manual
Page 22
23
LED Indicators
The LED indicator is located on the right side speaker in the logo plate. It is used to help you monitor and
control your audio system.
•
NO LED ON – The system is either unplugged or powered off .
•
Green LED – The system is powered on.
•
Blue LED – Hearing impaired mode is ac ve.
•
Red LED – The red LED indicates mul ple func ons:
◦
Audio is muted from the remote control.
◦
The system is in auto power down mode. This is caused when no audio is detected for an
extended me.
◦
When the system has reached maximum volume, the LED will turn red each me you press the
volume up bu on on the remote control.
◦
When adjus ng the Bass, Treble or BAL controls, the blue or green LED will change to red
momentarily to indicate that the center point or end point have been reached for the control
being used.
Power On/Off
1.
Turn on your TV.
2.
Turn on the Audio Mount using the remote control supplied with the unit.
3.
Select the Audio input source on the Audio Mount Remote (LINE or OPT, depending on which
connec on you chose to connect from the TV to the Audio Mount).
Operating Modes
Your Audio Mount has two modes of opera on: Normal and Hearing Impaired. When in Normal mode, the
LED illuminates green and the system is set to Normal frequency response. In Hearing Impaired mode, the
LED illuminates blue the audio is enhanced to improve the clarity of voice frequencies.
Press the
bu on on the Audio Mount remote control to select the preferred opera ng mode. This
bu on is a toggle and will change between the modes each me it’s pressed.
Volume Control/Mute
Press the VOL + bu on to increase the volume. When you have reached maximum volume level, the limit
the LED will turn RED.
Press the VOL – bu on to decrease the volume. When you have reached the minimum volume level, the
LED will turn RED.
Press the MUTE bu on on the Audio Mount remote control to toggle between audio on and mute.
NOTE: The Audio Mount Remote Control does not func on in a press and hold mode. You must depress
the bu on mul ple mes to increase or decrease the Volume.
OPERATION