BINDER M 53 - Manual (Page 16)

M (E2) 10/2014 page 16/71
If you need to return the unit, please use the original packing and observe the guidelines for safe lifting
and transportation (chap. 3.2).
For disposal of the transport packing, see chap. 13.1.
Note on second-hand units (Ex-Demo-Units):
Second-hand units are units that were used for a short time for tests or exhibitions. They are thoroughly
tested before resale. BINDER ensures that the chamber is technically sound and will work flawlessly.
Second-hand units are marked with a sticker on the unit door. Please remove the sticker before commis-
sioning the unit.
3.2 Guidelines for safe lifting and transportation
The front castors of the M 720 can be blocked by brakes. Please move the units with castors only when
empty and on an even surface, otherwise the castors may be damaged. After operation, please observe
the guidelines for temporarily decommissioning the unit (chap. 13.2).
CAUTION
Sliding or tilting of the unit.
Damage to the unit.
Risk of injury by lifting heavy loads.

Transport the unit in its original packaging only.
 For moving or shipping, secure the drying and heating oven with transport straps
 Do NOT lift or transport the unit using either the door or the handle.
 Do NOT lift units size 400 and 720 by hand.
 Lift units size 53, 115 and 240 near the 4 unit feet with the aid of 4 people and place it
on a transport pallet with wheels. Push the pallet to the desired site and then lift the
unit near the 4 unit feet from the pallet.
 Place units size 400 and 720 using technical devices (fork lifter) on the transport pallet.
Set the fork lifter only from the rear in the middle of the unit. Make sure to place all the
lateral supports of the unit on the forks.
 Transport units size 400 and 720 ONLY with the original transport pallet. Set the fork
lifter only to the pallet. Without the pallet the unit is in imminent danger of overturning.
• Permissible ambient temperature range during transport: -10 °C to +60 °C / 14 °F to 140 °F.
You can order transport packing and pallets for moving or shipping purposes from BINDER Service.
3.3 Storage
Intermediate storage of the unit is possible in a closed and dry room. Observe the guidelines for tempo-
rary decommissioning (chap. 13.2).
•
Permissible ambient temperature range during storage: -10 °C to +60 °C / 14 °F to 140 °F.
• Permissible ambient humidity: max. 70 % r.H., non-condensing
When after storage in a cold location you transfer the unit to its warmer installation site, condensation
may form. Before start-up, wait at least one hour until the chamber has attained ambient temperature and
is completely dry.