BIXOLON SRP-770II - Manual (Page 23)

Rev. 1.19 - 23 -
SRP-770II/770IIE
5-7 Auto Cutter (option)
Auto cutter should be used for continuous paper only. ( i.e. roll paper)
1. Open the Dip switch cover, and make the switch 1 number 7 “On”.
(Refer to printer mode setting at Chapter 5-1.)
2. Put a paper roll into the printer and close the cover.
SA
MS
UN
G
LA
BE
L P
RN
TE
R
※ CAUTION (Partial cut)
Once the printer cut the paper, remove the receipt in order for next printing.
Otherwise the receipt could be back into the printer and the cutter would cut it again.