Dodge 2007 Ram Chassis Cab - Manual (Page 24)

Transmitter Battery Service
NOTE: Perchlorate Material – special handling may
apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate
The recommended replacement battery is CR2032 bat-
tery.
NOTE: Do not touch the battery terminals that are on
the back housing or the printed circuit board.
1. With the transmitter buttons facing down, remove the
small screw, and separate the two halves of the transmit-
ter. Make sure not to damage the rubber gasket during
removal.
2. Remove and replace the battery. Install the battery
with the positive terminal up, reference the note “+ SIDE
UP” on the inside of the bottom half of the transmitter
case. Avoid touching the new battery with your fingers.
Skin oils may cause battery deterioration. If you touch a
battery, clean it with rubbing alcohol.
3. To reassemble the transmitter case, join the two halves
of the case together. Install and tighten the screw until
snug. Make sure there is an even “gap” between the two
halves. Test transmitter operation.
Transmitter Battery Replacement
24 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE