Remote control issues recording issues – Channel Master DVR+ (7500GB16) User Manual

Page 39

Advertising
background image

33

Troubleshooting ::

Remote

Control Issues

Recording

Issues

•

Ensure the batteries are functional; when you press a button on the

remote control, the

POWER button (or TV POWER button) should

light up briefly.

•

Ensure the batteries are installed as indicated on the diagram inside

the battery compartment, and that you have pulled out the arrow-

shaped piece of plastic to remove it from the compartment for first

use of the remote. Old (discharged) batteries should be replaced

with (2) fresh CR2032 batteries.

•

Ensure you are holding the remote control with the lens at the top of

the remote pointing directly at the front of your DVR+.

•

Ensure that the IR window in the center of the DVR+ front panel is

not covered or obstructed. If your DVR+ receiver is installed in a

location without a clear line-of-sight to the remote, you can obtain

an optional IR extender; visit

support

.channelmaster.com for more

information on this and other accessories.

•

If the remote controls your DVR+ but not your TV, then ensure the

remote is set up correctly to control your TV (see pages 11-13). You

will need to do this whenever you change batteries.

•

Your DVR+ receiver must be powered on or in standby mode when a

program or event is scheduled for it to be recorded.

•

If your external disk cannot be detected by DVR+ software or is not

working correctly, first try the Check Disk option on the DVR Setup

submenu of the DVR menu. This will reboot the drive.

•

If you would like to keep more recordings than there is space on

internal memory, consider purchasing a USB external hard-disk

drive for additional storage and connecting it to one of the USB ports

on your DVR+ rear panel (see page 4). When an external drive is

connected, additional DVR features are made available such as

recording two programs at once and pausing live TV.

•

View issues causing DVR timers to fail (such as insufficient tuners,

recording capacity or signal strength) by pressing the

MENU button,

highlighting and selecting the DVR menu, then Recording History.

•

Verify that event timers are set as DVR timers, not as Reminder

timers. Confirm an event recording is set up by looking for a red

triangle on the corner of the guide listing for the event.

•

Verify that there is sufficient storage space for your recordings. You

can delete any watched recordings to save space.

•

To enable simultaneous recording of programs on two different

channels, connect an external USB hard-disk drive. For more details,

visit www.channelmaster.com.

•

If your network equipment appears to be working correctly, but

you still cannot access the Internet from devices connected to the

network, contact your Internet service provider for assistance.

•

To enjoy high-quality video streaming from online applications such

as VUDU, a 2 Mbps minimum connection speed is recommended. If

you are not sure of your connection speed, check with your Internet

service provider.

Advertising
This manual is related to the following products: