COMMELL HS-874P - Manual (Page 24)

HS-874P User’s Manual Hardware Setup
Digital Display 24
To setup the LCD, you need the component below:
1. A panel with LVDS interfaces.
2. An inverter for panel’s backlight power.
3. A LCD cable and an inverter cable.
For the cables, please follow the pin assignment of the connector to make a cable,
because every panel has its own pin assignment, so we do not provide a standard
cable; please find a local cable manufacture to make cables.
LCD Installation Guide:
1. Preparing the HS-874PX, LCD panel and the backlight inverter.
2. Please check the datasheet of the panel to see the voltage of the panel, and set the
jumper JVLCD to +5V or +3.3V or +12V
3. You would need a LVDS type cable.
4. To connect all of the devices well.
For sample illustrator only
Panel side Board side