COMMELL LE-376 User Manual
Page 24
LE-376 User’s Manual
-
22
-
To setup the LCD, you need the component below:
1.
A panel with LVDS interfaces.
2.
An inverter for panel’s backlight power.
3.
A LCD cable and an inverter cable.
For the cables, please follow the pin assignment of the connector to make a cable, because
every panel has its own pin assignment, so we do not provide a standard cable; please find
a local cable manufacture to make cables.
LCD Installation Guide:
1.
Preparing the LE-376, LCD panel and the backlight inverter
2.
Please check the datasheet of the panel to see the voltage of the
panel, and set the jumper JVLCD to +5V or +3.3V.
3.
You would need a LVDS type cable.
4.
To
connect all of the
devices well.
For sample illustrator only
Panel side
Board side