Dan Dugan Sound Design E-2 - Manual (Page 20)

Dugan Model E-2 User Guide
20
Analog
Move the ANA-DIGI switch to ANA (up position).
If you do not need the Dugan Music System, twelve channels of automixing are avail-
able using all three DB25 connectors.
The content of the AUDIO I/O 9–12 DB25 connector depends on the state of the #ch
switch. This can be set in the Dugan Control Panel (see Chapter 4: Dugan Control Pan-
el) or with a power-up command (see Appendix A: Power-up Commands).
+4/-10
This sets the input sensitivity, internal headroom, and output level between profes-
sional (+4) and consumer (-10) audio line levels.
8-Ch
• Eight automix channels on the AUDIO I/O 1–4 and AUDIO I/O 5–8 DB25 connectors
• Three Music System threshold inputs on the AUDIO I/O 9–12 (channels 9–11)
Channel 12 is an auxiliary input sent to the mix bus matrix.
• Four mix bus outputs on AUDIO I/O 9–12 (channels 9–12)
• Linking available on LINK IN, LINK OUT
• Unprocessed outputs are available on AUD OUT
NOTE: Since relays route the audio input signals for channels 1–12 directly to their respective
outputs when the unit is off, you can leave it patched when not in use.
12-Ch
• Twelve automix channels on all three DB25 connectors
• Linking available on LINK IN, LINK OUT
• Music System and mix buses not available