Document Outline

• Dataman-48UXP
  • Intelligent Universal Programmer
  • User(s Manual
  • Copyright Notice
  • Acknowledgments
  • How to use this manual
  • Packing List
  • 0
  • Quick Start
  • This section is for experience user only, after install the Dataman-48UXP hardware and successfully install the system software in your PC, user can follow the quick start section start to program the device without go to the read this manual step by ste
  • Quick Start
  • 1
  • General Information
  • Introduction
  • Features
    • • • • Universal adapter below 48 pin
  • Unbeatable speed
  • Device-insertion and continuity checks – No mistakes!
  • Auto-sensing and self-programming
  • Project file “Save and Load”
  • Variable VCC with one or two-pass verification
  • Using the Dataman-48UXP Software
  • Menus
  • Hot keys
  • 2
  • Installation
  • Minimum PC System Requirements
  • Installing the Dataman-48UXP Software
  • Upgrading the Dataman-48UXP Software
  • Command Hierarchy
  • Dataman-48UXP Command Hierarchy
  • 4
  • Operation
  • LED Display
    • • • Warning: Do not insert or remove a chip from a socket while the yellow LED is on (Busy)!
  • Flashing LED, 5Hz frequency. This only applies to mass production mode, the chip pass the program and verify cycle and waiting for operator to remove the chip and insert a new chip.
  • Save Buffer to File
  • Normal (default)
    • • • • • Odd
  • Even
  • Load File to Buffer
  • Auto Format Detected
  • From File to buffer
  • To Buffer
  • From File Address
  • To Buffer Address
  • Size
  • Clear Buffer Options
  • Disable
  • Blank state
  • 0x00
  • 0xFF
  • Exit
  • Project File Commands
  • Save Project
  • Load Project
  • Device Commands
  • Change Device
  • Mouse
  • Keyboard
  • Mouse
  • Keyboard
  • Editing the Buffer (memory device )
  • Fill
  • Copy
  • Search
  • Undo
    • • • • • • Modify Vector (only available when select PLD)
              • Undo
              • Insert
              • Copy
                • Cut
              • Edit the test vector
  • Blank Checking a Device
  • Reading a Device
  • Programming a Device
  • Verifying a Device
    • • • • • • • Special note for program configuration/ memory protect
                • Function Test (only available for logic chip)
  • Erasing a Device
    • • • • • • • Compare
  • Device Configuration
  • Options
  • Modify Programming Parameters
  • Device Operation Options
  • Start address, End address
  • Buffer size
  • Insertion Test
  • Device ID Check
  • Verify Passes
  • Verifying Options
  • (.) Twice Vcc ±5%
  • Example:
  • Example:
  • (.)Once
  • Blank Check
  • Program configuration/memory protect
  • Auto-Erase/Overwrite Option
    • • • • • • • Auto increment (only available to memory device)
  • Parallel Port Selection
    • • • • • • Failure count
  • 5
  • Using Adapters
  • Adapter Requirements
  • A
  • Error Messages
  • Error Messages
  • Cold not open file – nnnn!