Document Outline

• 1
• General Information
• Introduction
• Features
  • • • • Universal adapter up to 48 pin
• Unbeatable speed
• Device-insertion and continuity checks – No mistakes!
• Auto-sensing and self-programming
• Project file “Save and Load”
• Variable VCC with one or two-pass verification
• Using the DATAMAN-48XP Software
• Menus
• Hot keys
• 2
• Installation
• Minimum PC System Requirements
• Installing the DATAMAN-48XP Software
• Upgrading the DATAMAN-48XP Software
• Command Hierarchy
• DATAMAN-48XP Command Hierarchy
• 4
• Operation
• LED Display
  • • • Warning: Do not insert or remove a device from the socket while the yellow ’Busy’ LED is on!
• Flashing LED at 5Hz frequency. This only applies to mass production mode. The chip has passed the program and verify cycle and is waiting for the operator to remove it and insert a new one.
• Save Buffer to File
• Normal (default)
  • • • • • Odd
• Even
• Load File to Buffer
• Auto Format Detected
• From File to Buffer
• To Buffer
• From File Address
• To Buffer Address
• Size
• Clear Buffer Options
• Disable
• Blank state (default)
• 0x00
• 0xFF
• Exit
• Project File Commands
• Save Project
• Load Project
• Device Commands
• Change Device
• Mouse
• Keyboard
• Mouse
• Keyboard
• Editing the Buffer (memory device )
• Fill
• Copy
• Search
• Undo
  • • • • • • Modify Vector (only available when selecting PLD)
            • Undo
            • Insert
            • Copy
              • Cut
            • Edit the test vector
• Blank Checking a Device
• Reading a Device
• Programming a Device
• Verifying a Device
  • • • • • • • Special note for program configuration/ memory protect
              • Function Test (only available for logic chip)
• Erasing a Device
  • • • • • • • Compare
• Device Configuration
• Options
• Modify Programming Parameters
• Device Operation Options
• Start address, End address
• Buffer size
• Insertion Test
• Device ID Check
• Verify Passes
• Verifying Options
• (.) Twice Vcc ±5%
• Example:
• Example:
• (.)Once
• Blank Check
• Program configuration/memory protect
• Auto-Erase/Overwrite Option
  • • • • • • • Auto increment (only available to memory device)
• Parallel Port Selection
  • • • • • • Failure count
• 5
• Using Adapters
• Adapter Requirements
• A
• Error Messages
• Error Messages
• Could not open file – nnnn!