Dataman 40Pro - Manual (Page 157)

PG4UWMC
157
Search in Programmers group on network
From this point, working with PG4UWMC should be as usual.
Troubleshooting
If searching programmers does not finish as expected, please check following:
each computer in Programmers group must run PG4UWMC Network Agent with
same Programmers group
your firewall settings may block network communication, please check firewall rules or
temporally disable firewall.
Command line parameters
Program PG4UWMC supports following command line parameters:
/prj:<file_name>
Loads project file. Parameter <file_name> means full or relative project file path and name.
There is also available to make Load project operation from command line by entering project
file name without prefix /prj:...
Example:
pg4uwmc.exe c:\projects\myproject.eprj
Makes load project file "c:\projects\myproject.eprj".
/autoconnectsites
The command forces PG4UWMC to connect programmer Sites (start control program
PG4UW for each Site) during start of PG4UWMC, for all Site-s that were used, when
PG4UWMC was recently closed. There is also equivalent option "Auto-connect Sites"
available in "Settings" dialog of PG4UWMC.